[. . . ] *Note : 2 colons If there is more than one three-digit number listed for your brand, try one code number at a time until your component turns off. STEP4 Store the three-digit code number by pressing the same [COMPONENT] button once again. [. . . ] The component LED light will indicate the three digits that comprise the code number by blinking the corresponding number of times for each digit, separated by a one second interval, during which time the component LED light will turn off. Example : One blink, three blinks and eight blinks, separated by a one second interval during which time the component LED light turns off, indicates a code number of 138. *Note : Ten blinks is equal to the number 0. 2 Replacing Batteries Before you program or operate the remote control, you must install two new AAA alkaline batteries. STEP1 Remove the battery compartment cover on the back of your remote control. STEP2 Check battery polarity carefully, and install the batteries as shown in the illustration below. Auto Search Method. If the three-digit code numbers assigned to your brand do not turn off your component or the code tables do not list your brand, you can use the Auto Search Method to find the correct three-digit code number for your component by performing the following steps: STEP1 Turn on the component you wish to operate. STEP2 Press the [COMPONENT] button (TV, VCR, DVD or AUX) to be programmed and the [OK] button simultaneously for 3 seconds. *Tip : If you do not press either the CH+ or CH- button within 20 seconds, the component button LED light will turn off and exit set-up mode and you will need to start over. STEP3 Press the [CH+] or [CH-] button one step at a time or keep it pressed. *Tip : You can verify that you selected the correct code by pressing the [POWER] button again. Programming Volume Control . By following the steps below, the user can program the volume controls (Volume Up, Volume Down and Mute) from one device to operate in another device mode. The default volume control settings on the remote control is as follows : STB : TV TV : TV VCR : TV AUX : AUX lf you wish to store the STB volume control in STB mode, use the following steps. [. . . ] The selected component LED light will turn on indicating the component is ready to be programmed. *Tip : If you do not begin entering code numbers within 20 seconds, the component LED light will turn off and exit set-up mode and you will need to start over. [. . . ]